Varastotilanne ja saapuvat
Sijainti myymälässä Myymälä Vantaa
The Xerun 4268 G3 motor offers RC drivers of 1/8 onroad models great driving fun with even better performance. It owes this to the improved design and the efficiency in combating the heat that arises. Because compared to the G2 predecessor engines, this has been increased by 6%, which significantly reduces the heat generation.
100% sensor mode
With the built-in chip, the Xerun G3 motor can also be recognized by Hobbywing Xerun XR8 controllers. This combination results in a 100% sensor-controlled drive system. In addition, the Hall sensor system ensures a clean and stable run in sensor mode.
Note: If the motor is connected to other controllers, there is no guarantee that the sensor mode is active.
Turbo timing technology
When used with a controller from the XERUN XR8 series, "Turbo Timing" can also be activated. This is already used very successfully in the 1/10 on-road area and also releases the last power reserves of the engine.
Low heat development
Low detent torque
High quality materials and excellent workmanship
Dust-tight according to IP5X standard (1900kV, 2200kV and 2250kV)
Type: Brushless Sensored
Consumption without load: 4.2A
Cell count LiPo: 2-6S
Number of poles: 4th
Shaft diameter: 5mm
Timing: 20-40 degrees (adjustable)
Commitment: 1/8 on-road
1x sensor cable
1x user manual (English)